Microtel DialStat (With Fault Indicators) Bedienungsanleitung PDF herunterladen (Seite 10)

MICROTEL DialStat

CHAPTER 2 - Installation

nstallation of the DialStat

involves several, simple steps. This chapter outlines the

physical connections to the dialer. At the end of this chapter is a Quick Start

procedure which summarizes the configuration procedure of the dialer.

Step One - Connect the Power Supply Connect the supplied external

transformer to the 12 VDC terminals as shown in Figure 2 below. Plug the transformer

into a MicroMax Surge Suppressor (Recommended by Microtel).

NOTE: Alternatively, you may connect any 12 to 20 Volt DC power (such as a solar

panel) to the dialer. Connect the positive side of the voltage source to 12VDC+, and the

COMMON lead to 12VDC- of the power supply terminal block of the dialer.

NOTE: Although the dialer will operate and place telephone calls when operating on its

standby battery, external power must be present whenever you wish to configure/query

the dialer from the local phone PHONE jack.

Figure 2. Power Supply Connection

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Keine Kommentare

Microtel DialStat (With Fault Indicators) Bedienungsanleitung Seite 10